How to use solar high temperature adhesive tape correctly?

Proper use of solar high-temperature adhesive tape requires preparation before construction, standardized operation during construction and inspection after construction, as follows:

Preparation before construction

Confirm the specification and performance of the adhesive tape: according to the use environment, temperature requirements and specific sticking parts of solar equipment, select the solar high-temperature adhesive tape with appropriate specifications and performance. For example, for the sealing of solar panel frame that needs to work in high temperature environment for a long time, adhesive tape with good long-term temperature resistance should be selected.

Cleaning the surface to be pasted: use clean cloth or solvent to thoroughly remove dust, oil stain, water stain and other impurities on the surface to be pasted to ensure that the surface is dry, clean and smooth, so as to improve the pasting effect and adhesion of the adhesive tape.

work progress

Cutting adhesive tape: according to the actual sticking length and shape, use scissors or special cutting tools to cut the adhesive tape to a suitable size, and try to ensure that the cutting edge is neat to avoid jagged or irregular edges, which will affect the appearance and sealing performance.

Sticking the adhesive tape: uncover the release paper of the adhesive tape, fix one end of the adhesive tape at the initial position of the adhesive surface, and then gently press the adhesive tape with fingers or tools to make it stick to the surface evenly, and remove the air between the adhesive tape and the surface while sticking to avoid bubbles or wrinkles. For a long pasting part, it can be pasted in sections to ensure that the tape is always flat.

Ensure firm pasting: after pasting, press the adhesive tape again, especially the edge part of the adhesive tape, to ensure that it is fully contacted with the pasting surface and pasted firmly, so as to prevent the edge from tilting or falling off during use.

Inspection after construction

Appearance inspection: check whether the adhesive tape is smooth and beautiful, and whether there are any problems such as bubbles, wrinkles, and raised edges. If problems are found, they should be adjusted or re-pasted in time.

Performance test: If conditions permit, simple performance test can be carried out on the pasted tape, such as checking whether its high temperature resistance and water resistance meet the requirements. For example, under the working temperature environment of simulated solar energy equipment, observe whether the adhesive tape appears discoloration, shedding and other phenomena.

When using solar high-temperature adhesive tape, it is necessary to operate in strict accordance with the product instructions, and pay attention to safety during use to avoid contact with skin and eyes. If it is accidentally contacted, it should be washed with plenty of water immediately and seek medical attention in time.